[FSPA] deep ball trails/dremel?

[Steve Peck]

Thanks for the info. most of the trails are in places that arent visible,
(inner loop that's under a side ramp, etc) and i'm planning on applying
mylar to these locations.

I may have done a poor job explaining as well. for the most part the trails
are barely more severe than what novus can handle.

I ended up having success using novus 2 on a dremel polishing pad @ 5k rpm

On Wed, Aug 2, 2017 at 12:21 PM, The Bob via FSPA <fspa at fspazone.org> wrote:

> Uh...playfield polishing at least what you're talking about is best done
> with a random orbit polisher.  If it's like an inlane groove or something
> localized and fairly hidden you could try the dremel.  You could also try
> Novus 3 but realize it's going to cut through the clear coat pretty quickly.
>
> I'd read the Vid1900 thread on playfield refurbishment on Pinside before I
> went nuts though.
>
>
> On Wed, Aug 2, 2017 at 11:48 AM, Steve Peck via FSPA <fspa at fspazone.org>
> wrote:
>
>> Hey guys,
>>
>> I have a mid 90s dmd with a pretty nice playfield but there's a few spots
>> where the ball trails have actually caused scratching/contour and wont come
>> up with just novus 2.
>>
>> Anything i can do about those areas perhaps with a dremel? i have a wide
>> variety of heads including polishing pads.
>>
>> Any other solutions are welcome as well.
>>
>> thanks,
>> Steve
>>
>> _______________________________________________
>> FSPA mailing list
>> FSPA at fspazone.org
>> http://lists.fspazone.org/mailman/listinfo/fspa
>>
>>
>
> _______________________________________________
> FSPA mailing list
> FSPA at fspazone.org
> http://lists.fspazone.org/mailman/listinfo/fspa
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.fspazone.org/pipermail/fspa/attachments/20170802/3e9780e1/attachment.html>